01 good finish & painting
Does not require or only a very small amount of cutting;Because it is suitable for mass production, the production efficiency is high and the cost is lower than that of cutting
02 same weight as original one
The surface of the part can be processed according to customer requirements to improve the strength and hardness; High material utilization rate, up to 95%; Good dimensional consistency and stability
03 GOOD FITTING
Material composition can be adjusted according to customer part performance requirements; Due to the use of mold forming, it is possible to produce complex or oddly shaped parts that could not be manufactured in total
04 Sufficient supply capacity
All our products comply with international quality standards and are greatly appreciated in a variety of different markets throughout the world.